|
Post by quaysider on Nov 6, 2017 16:43:33 GMT
Cheers Peter - it was you that got me thinking (and reading) about the gtps... The current combi inverter/charger from a "does what it says on the box" point of view IS very good for the money - 499 quid. It will run everything we need with ease - including the 2.2kw tumble-drier with ease (although even with the engine running, the drier has to be on "low" or the soc goes down. AND it has the built in 90amp charger which works fine from the new generator.
It's a clumsy test, but with the clamp meter on the cables to the batteries, just turning it on draws 5.8( ish)amp. The standby isn't too bad but there's little point in using that as it doesnt recognise toothbrush chargers.
As smiley says though, it WORKED a treat during the build... a side from the washer (which I always use on cold but put 10 litres out of the hot water tank in) and a fews mins of microwaving a day, everything else is 12 v. The tvs are, I've a couple of laptop adaptors to up it from 12 to 19v to charge them, the mifi points are usb, as are the reading lights and phone chargers.
I think if we hadn't hammered the original batteries with the webasto / ahem, halogen heater before that, they'd have lasted better.
|
|
|
Post by thebfg on Nov 6, 2017 17:01:26 GMT
I think if we hadn't hammered the original batteries with the webasto / ahem, halogen heater before that, they'd have lasted better. As a simpleton, that says to me that when the time comes, you could almost replace like for like as they will fair better now your not on the fit out and I presume your battery skills are getting better.
|
|
|
Post by lollygagger on Nov 6, 2017 19:08:56 GMT
2.2kw tumble drier on inverter. Let's see how the batteries might like that... 2200W/12V= 183A. Eek!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 6, 2017 19:19:59 GMT
2.2kw tumble drier on inverter. Let's see how the batteries might like that... 2200W/12V= 183A. Eek! Dived by 10 to allow for the inefficacy of chopping 12v DC to 230v AC and it's even worse!
|
|
|
Post by smileypete on Nov 6, 2017 19:37:36 GMT
Cheers Peter - it was you that got me thinking (and reading) about the gtps... With anything too unusual I'd let someone else be the guinea pig, reminds me of MtB on CWDF and his 'Trojanoids' If the idea of trying some careful SG checking and eq charging on the current batts doesn't appeal, then maybe get some decent leisures and see how they go with better care? Otherwise will you want to have to fuss over some proper Trojans when the need arises? That said the current batts can't be too bad if they run heavy inverter loads OK. Glad the inverter is OK enough, sounds like the washer is a bit over the limit for it. Maybe a small pure sine inverter would do OK for the toothbrush chargers and other small stuff.
|
|
|
Post by markhez on Nov 8, 2017 10:53:48 GMT
I've just bought a smaller inverter to use to charge phone and iPad in the winter, because of the reasons you mention ie the current drawn by a large inverter on standby. If I was you Id try to get the most out of the batteries you've got before replacing them. In other words rinse them. Any reason why you're using an inverter to charge them? Doesn't make much sense when the iPad and your phone will both want a DC input.
|
|
|
Post by Telemachus on Nov 8, 2017 11:23:53 GMT
|
|
|
Post by kris on Nov 8, 2017 12:21:02 GMT
I've just bought a smaller inverter to use to charge phone and iPad in the winter, because of the reasons you mention ie the current drawn by a large inverter on standby. If I was you Id try to get the most out of the batteries you've got before replacing them. In other words rinse them. Any reason why you're using an inverter to charge them? Doesn't make much sense when the iPad and your phone will both want a DC input. mainly because of the distance from the battery bank, to where I use them. I don't have 12v run from the workshop to the living space yet. Yes I can charge them from 12v in the workshop.
|
|