Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 21, 2021 7:24:15 GMT
I need a burner for the spare boat as the burglar nicked the existing one and the diesel heater. Spotted this one which oddly is just up the road from where I lived when I was physically 11 years old. I still am mentally 11 years old although my physics do not seem to agree. Anyway it's like this: Looks like former user has bodged it by just placing a round flange over it and fire cement. I dislike fire cement enormously and would baulk at using it for problem solving. I'd rather get an adaptor for it really. Headache worth avoiding or potentially interesting if done right is the question.. Slightly intriguing stove. Inside it looks great with ribbed fire bricks so I think it's an old one. The acorn nuts seem to indicate a rebuild at some stage as they look stainless or perhaps brass. It might be a modern thing I'm not sure. At least it doesn't have bumps on the hotplate lids like the Andyberg one had. ETA I do like a top flue exit on a fire. I was thinking perhaps a 8mm plate plasma cut then a flue spigot welded onto it might be the thing but it could interact negatively with the cast iron and cause a crack.
|
|
|
Post by JohnV on Nov 21, 2021 8:36:30 GMT
Morning Andrew
Interesting one. Probably someone somewhere will have an adaptor but it might be hard to track down.
I reckon your 8mm plate with a spigot is the best idea, make it a gnats cock smaller than the inset in case of different expansion rates and use a gasket under it .... you can get small sheets of aramid based gasket about 1mm thick quite cheap.
If Gazza reads this he will quite likely have a better engineering solution but if not, that's probably the way I'd try
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 21, 2021 8:48:22 GMT
There are places that could cast you a new adapter it could even have a cleaning door 😱
|
|
|
Post by Jim on Nov 21, 2021 10:13:58 GMT
Had a stove like that years ago in my house. Pulled it out of a ruined farmhouse up on the moors. Cracked bits repaired with nickel welding rods. Fashioned a back boiler out of copper, ran 2 radiators and a hot water tank from it on free wood.
There should be an oval to round casting about 200mm high. I don't recall it having a rodding hatch, it might have done. Easy enough to fabricate an oval steel plate with a round hole and flange.
|
|