|
Post by faffer on Aug 7, 2017 16:24:33 GMT
As always there is a problem when i try to do something. One screw snaps off in twenty or tape measure goes missing again just when i need it and shops are shut etc etc. Now i have gone and lost the knuckle on the end of the hinge on the Houdini 500 hatch as below. So by a chance of a miracle has anybody got one spare or can remove from a hatch that is gong for scrap pleas. I need the right hand knuckle and screws if you can please. Or complete hinge. PM if you can help please Cheers Wayne
|
|
|
Post by IainS on Aug 7, 2017 20:36:23 GMT
Any of them any good?Drill for hinge pin and screw (or might need tapped?), file or grind a flat on one corner, quick rub over with sandpaper/emery to get the sharp edges off; job done!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 7, 2017 20:40:43 GMT
Looks like a fairly straightforward job to make one as it's aluminium.
|
|
|
Post by faffer on Aug 8, 2017 18:55:49 GMT
All sorted now chaps, i will be making a full set from a larger bar a si need them slightly bigger now as had a brain wave of sorts I was just being a lazy git lol.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 8, 2017 19:09:57 GMT
All sorted now chaps, i will be making a full set from a larger bar a si need them slightly bigger now as had a brain wave of sorts I was just being a lazy git lol. It's not lazy, it's maximising the use if your time 👍🚢🍻⚓
|
|