Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 17, 2020 13:02:28 GMT
The Bob Yak single wheel trailers have dropouts which slide over machined spindles on the quick release skewers. Then there is an R clip which slides in to lock in place. Takes a few seconds.
But you need to have a bike with quick release wheels. The trailer comes with custom skewers with the little spindles on the ends.
Quite a good system.
Not sure about the two wheel ones.
|
|
|
Post by kris on Apr 17, 2020 14:05:41 GMT
Mine is a bit bigger but that would be ideal. Thanks BFG, can I ask something? Are there disadvantages in a trailer that attaches to the seatpost? Most attach via a bracket added onto the rear of the bike- I think they go onto the axle/spindle itself if I can it right- is that correct? Or do they attach to on of the extra lugs that are usually on the frame, near to the axle, e.g the ones you use to attach mudguards etc? Obviously I want something quick release (ish), and I think all the seat post designs looked easy/quick to undo, whereas some of the lower- mounted ones seem to need a nut undoing to get them on or off the bike. Just wondering if you were aware of any issues with either design really? The trailers that attach to the wheel spindles or somewhere near are the best. Because of the centre of gravity and where you are pulling the trailer from. Personally I wouldn’t have a two wheel trailer as they are a pain in the back side. Turning circle and the width of the load mean that it’s not as nimble or manoeuvrable as a bike. Whereas a single wheel trailer if loaded properly doesn’t feel to bad.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 17, 2020 14:34:22 GMT
I'd be worried about hooking a two wheel trailer up on kerbs and the like. Plus twice the probability of getting a puncture. The sooner someone works out a better option than wheels the better And I don't mean the Telemachus option I mean hovering close to ground. Like one inch away.
|
|
|
Post by Jim on Apr 17, 2020 14:37:54 GMT
I'd be worried about hooking a two wheel trailer up on kerbs and the like. Plus twice the probability of getting a puncture. The sooner someone works out a better option than wheels the better And I don't mean the Telemachus option I mean hovering close to ground. Like one inch away. Does Telemachus ever touch the ground?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 17, 2020 15:11:55 GMT
I thought the general consensus was that he had hit the ground running years ago.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 17, 2020 18:25:53 GMT
Thanks Kris and Magnetman, my wheels aren't QR and I don't fancy undoing the axle/spindle nut every time I want to use it, if poss.
So I'm looking for a system with a mounting point that attaches 'permanently' to the rear wheel or frame, but the trailer can be quickly unhooked with a catch mechanism of some sort.
I think one wheel might be a bit better, but I'm not that fussed at the moment between one wheel or two. BFG seems to have done a fair few miles towing his two-wheeler, so I'm not ruling two wheels out the moment. Might need to do more research, look at more reviews, etc.
Some two wheelers will carry 50kg or more, so if I was ever stuck for coal unexpectedly in a more remote area, I could maybe get two 25kg sacks into a two wheeler. Do you think one-wheel trailers have less stability with heavier loads?
|
|
|
Post by Jim on Apr 17, 2020 19:09:59 GMT
Thanks Kris and Magnetman, my wheels aren't QR and I don't fancy undoing the axle/spindle nut every time I want to use it, if poss. So I'm looking for a system with a mounting point that attaches 'permanently' to the rear wheel or frame, but the trailer can be quickly unhooked with a catch mechanism of some sort. I think one wheel might be a bit better, but I'm not that fussed at the moment between one wheel or two. BFG seems to have done a fair few miles towing his two-wheeler, so I'm not ruling two wheels out the moment. Might need to do more research, look at more reviews, etc. Some two wheelers will carry 50kg or more, so if I was ever stuck for coal unexpectedly in a more remote area, I could maybe get two 25kg sacks into a two wheeler. Do you think one-wheel trailers have less stability with heavier loads? My dog trailer has a peg and tube attachment, fixed with a clevis pin. The peg goes on the spindle, permanently. The tube, on the end of the drawbar, has a double knuckle, to move on both axes. I had no problem hauling the dog in it, just followed along behind. I wouldn't have thought a couple of bags of coal would be a problem. The frame is steel, the fibreboard floor I'd maybe strengthen, the cover is nylon, the wheels come off and it all folds flat. Here you go www.ebay.co.uk/i/382346113435?chn=ps&norover=1&mkevt=1&mkrid=710-134428-41853-0&mkcid=2&itemid=382346113435&targetid=876737317573&device=m&mktype=pla&googleloc=9046663&poi=&campaignid=9794971113&mkgroupid=98649235863&rlsatarget=pla-876737317573&abcId=1139126&merchantid=101748804&gclid=CjwKCAjwp-X0BRAFEiwAheRuiyQiMESWmvPWYoBL1m-OU1jO8Q6m5v2IK1df4IzaYtxiDWJ41UvDmxoCmPYQAvD_BwE
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 17, 2020 20:11:37 GMT
Thanks Kris and Magnetman, my wheels aren't QR and I don't fancy undoing the axle/spindle nut every time I want to use it, if poss. So I'm looking for a system with a mounting point that attaches 'permanently' to the rear wheel or frame, but the trailer can be quickly unhooked with a catch mechanism of some sort. I think one wheel might be a bit better, but I'm not that fussed at the moment between one wheel or two. BFG seems to have done a fair few miles towing his two-wheeler, so I'm not ruling two wheels out the moment. Might need to do more research, look at more reviews, etc. Some two wheelers will carry 50kg or more, so if I was ever stuck for coal unexpectedly in a more remote area, I could maybe get two 25kg sacks into a two wheeler. Do you think one-wheel trailers have less stability with heavier loads? My dog trailer has a peg and tube attachment, fixed with a clevis pin. The peg goes on the spindle, permanently. The tube, on the end of the drawbar, has a double knuckle, to move on both axes. I had no problem hauling the dog in it, just followed along behind. I wouldn't have thought a couple of bags of coal would be a problem. The frame is steel, the fibreboard floor I'd maybe strengthen, the cover is nylon, the wheels come off and it all folds flat. Here you go www.ebay.co.uk/i/382346113435?chn=ps&norover=1&mkevt=1&mkrid=710-134428-41853-0&mkcid=2&itemid=382346113435&targetid=876737317573&device=m&mktype=pla&googleloc=9046663&poi=&campaignid=9794971113&mkgroupid=98649235863&rlsatarget=pla-876737317573&abcId=1139126&merchantid=101748804&gclid=CjwKCAjwp-X0BRAFEiwAheRuiyQiMESWmvPWYoBL1m-OU1jO8Q6m5v2IK1df4IzaYtxiDWJ41UvDmxoCmPYQAvD_BwEThanks Jim, that looks just the job. I'll come back and let you know what I eventually get. If I do get a dog, this is it hands down
|
|
|
Post by Jim on Apr 18, 2020 9:22:53 GMT
Thanks Jim, that looks just the job. I'll come back and let you know what I eventually get. If I do get a dog, this is it hands down Dog or no dog, if you can get one cheap....
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 18, 2020 9:27:57 GMT
How about a social distancing bicycle? Almost fulfils the new requirements but not quite wide enough. Should be okay. At least you are making an effort. cover the seats in sheets to protect from coal dirt. Subject to tape measure you might want orange "keep 40cm clear" stickers on the side.
|
|
|
Post by JohnV on Apr 18, 2020 9:32:26 GMT
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 18, 2020 9:35:03 GMT
Good idea !
Excellent towpath vehicle.
|
|
|
Post by JohnV on Apr 18, 2020 9:37:50 GMT
was trying to post the image but first try was (as I presume you saw) half a page of gibberish ...... sigh ........ modern technology
|
|
|
Post by kris on Apr 18, 2020 9:38:02 GMT
Good idea ! Excellent towpath vehicle. if you’ve got a dog.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 18, 2020 9:39:59 GMT
What about making an electric crawler unit for it?
|
|